Four Reasons To Choose Industrial Heaters

The main application area of industrial heaters families 'ThermoRang 8,5' – this is a low-temperature heating units of production machines: material cylinders termoplastoavtomatov, extruders, preliminary and operating the heating molds, including hot runner, etc. The main consumers of our heaters are the manufacturers of the equipment and maintenance service of large industrial enterprises with a most cases, high-quality and high performance imported equipment operating in two – three shifts. Because of the above equipment is used in large scale and mass production, where time lost because of problems are very expensive, it puts special demands on the reliability of all units, including and heaters. Therefore, reliability, develops and distributes products' Belterm "attached special significance. Each newly created model heater is placed on production only after the endurance test and confirm the reliability parameters. The second feature of the establishment of industrial heaters families 'ThermoRang 8,5', is the lack of restrictions on the range, quantity and timing of production. Number of modifications of the heaters being developed within a month, could run into thousands of pieces, and the term production may be one day.

In this case the supply voltage can vary from 12 to 1000, the diameters of the ring (Semiring) heaters – 25 to 1000 mm or more heaters may be complicating elements: the grooves, notches, holes, disclosed for mounting on a heated object, etc. In spite of this, each heater has a full set of technical documentation, enabling him to produce and control the quality of manufacturing. The prices for Heaters family 'ThermoRang 8,5' remain lower than those of competitors, and the quality higher. This was made possible by the introduction of computer aided design (CAD), allowing for all of the requirements normative and technical documentation, and reduce errors in the design of the heaters, as well as to minimize the difference in price between serial and single samples. Third feature of the establishment industrial heaters families' ThermoRang 8,5 "is the constant improvement of technological level of production and creating new designs.

Because the market is saturated with industrial heaters, both domestic and foreign suppliers, then no innovation in this area rely on the long term is impossible. Therefore, the creation and innovation 'Belterm pays special attention. The fourth feature of the establishment industrial heaters families' ThermoRang 8,5 "is the constant enhancement of technological capabilities that allow improve quality and innovate. Achieved our current level of technology allows produce winding resistance elements on the ring frames (Clamp, lip, Obruchev) heaters with step 0.1 mm, and heat flux with heat transfer surface heaters with insulators on the basis of mica reaches the world level – 8,5 W / cm. square. The quality of the inner surface of the annular heater ensures virtually perfect fit cylindrical heat transfer surfaces. Today 'Belterm "accumulated extensive experience creating heaters, allows us to produce industrial heaters of almost any complexity and for any equipment, including import, but at much lower prices.