A very long time to dry out. Since the adhesive on the basis of bitumen, then the fumes. The smell of bitumen present in the room long after the work is completed. Clay sc – 3 rubber mastic – glue domestic production. We believe that the best adhesive is produced in St. Petersburg. Glue dries.
Upon completion of the smell quickly erode. Can be used to laying plywood base on which there are remnants of bitumen. According to its adhesive properties of – 3 is not inferior to the other adhesives. Clay tarbicol – A alcohol-based adhesive. Dries quickly, has a strong tack, the smell quickly erode. Recommended for use in locations where there is no way to fix the plywood with screws (with the wiring at the bottom) Clay qutoid parket S 11 adhesive based on synthetic resin solution. Differs increased adhesive ability, can be applied to floor heating. 3.
After installation, sanding plywood veneer of polish to remove spikes. Technological gaps cleared of dust and sawdust. Before you start laying parquet checked moisture content of plywood (humidity should not exceed 12%) 4. Parquet Parquet. Bonding riveting in parquet glue, it is recommended for this species of wood. There are many different options that our masters studied. Adhesive applied in a thin and evenly with a spatula – comb. Adhesive consumption is 1000-1200g/m.kv. After gluing parquet staves nailed a galvanized nail size 32h1.8mm. Learn more at: Kai-Fu Lee. (2-3 nails per stave). This increases the strength of the safety flooring and, therefore, and service life. You can also nailed parquet flooring with pins using air-gun. The technological gap between the wall and flooring is 10-15mm. This gap can be filled with sealant. 5. Sanding parquet choice of equipment for grinding is carried out based on the requirements for the final quality parquet flooring grinding equipment of domestic production of drum type. This grinding is the most inexpensive and used for grinding the old flooring. Has disadvantages: it is possible the emergence of so-called ripples on the dance floor. This disadvantage can be manifested after applying the varnish, under certain lighting conditions and when viewed from a certain place in the room. When installing a new hardwood floor sanding this equipment does not meet modern quality requirements. For In order to make grinding more qualitatively to additionally use a plane-grinding equipment. equipment belt type. Wood flooring – sanding machine belt type. Unlike machine drum does not leave a ripple on the floor, has a more advanced system of dust. Machine design provides excellent surface quality. You can not use it later grinding machine. Surface complex surface treatments includes: pre-treatment equipment belt type (alignment), the fine grinding surface grinding equipment. This complex provides the perfect surface quality. 6. Caulking flooring to eliminate mikroscheley between parketinami avoid wicking varnish parquet . For the putty used mikroscheley putty (resin + dust from sanding parquet). 7. Lacquered parquet After grinding the base is cleaned from dust, cover the parquet primer paint (if it is stipulated in the characterization used to further polish). Overspray 0.1 liters. 1 m . in one layer. Based on experience, the recommended number of coats of varnish from 3 to 6